CALCULATORS / LIGHTING RUN CALCULATOR
One lighting run.
Every component accounted for.
Plan the length, light inserts and suspension of your lighting run. Calculate profiles, connectors, suspension brackets, chains, link cables and blanking covers in one bill of materials.
Your entries stay with you. Save the bill of materials as a CSV file and use it when discussing your project with us.
Open Lighting Planner ↗Your bill of materials.
| Component | Specification | Per run | Total |
|---|
Free sections & link cables
Gaps of up to 6cm between light inserts are bridged by their existing leads and require no link cable. Gaps over 6cm require a 150cm link cable, which spans up to 160cm; each additional cable adds 150cm. Only gaps between light inserts are counted. Wiring from the power feed to the first insert is not included and must be checked separately.
Cutting plan for blanking covers
The calculator uses no 153cm profiles. It rounds up to a combination of 306cm and 459cm profiles, preferring 306cm profiles for the same total length. One connector joins each pair of profiles. Each run has one power feed and two end caps. Suspension points are 10cm in from each end, with no more than 250cm between points. One chain of the specified drop length is counted for each suspension point.
This bill of materials is a planning aid. Mechanical loads, building fixings, electrical design, connecting leads and the actual installation must be checked professionally before ordering. The cutting plan reuses offcuts but does not include cutting kerf. It is a feasible suggestion, not a guarantee of minimum waste.























